Nauticus boat leveler trim tab

• Color-coded wiring in 25' to 40' lengths with quick connects fittings, meets federal standards for heat, pull and insulation, making installation easy

• They are custom designed for Insta-Trim Boat Leveler Co., epoxy sealed and humidity resistant, thereby preventing shorting out
• The solenoids lock the tabs in any position, eliminating driftback. Barb type hose fittings provide tight, secure connections

• A powerhouse with coated wirings and a thermal overload that resists temperature and amperage build-up
• 1 3/4" stack windings and top mounting eliminated oil leakage
• The motor is mounted with stainless steel nuts and bolts, and is easily disassembled

• Swivel type brackets allow cylinders to be mounted an adjusted to any angle
• Knockout pins act as shear pins it tab strikes an object

• Designed and engineered exclusively by Instatrim
• The built-in bypass is factory set at 400 P.S.I. tolerance held to .00025
• Amperage doesn't exceed 16 because the unit circulates oil, rather than stalling out or trying to pump additional pressure

• 4 1/2" D x 6" W x 11"H, high impact ABS plastic cover with a built-in oil reservoir mounts easily with two screws
• The filler is located in front. Our cover protects the motor from occasional wash down

• Impact resistant, fiberglass reinforced nylon cylinders eliminates expansion and resists ultra-violet rays
• Two expanding type seals, plus O-ring, eliminates high and low pressure leaks
• Barbed cylinder fitting and an inserted tubular rod prevents hose blow-off and breakage
• A stainless steel spring retracts the cylinder when the boat is not in motion

• 12 gauge 304 stainless steel trim tabs are available in standard and custom lengths
• They are guaranteed against electrolysis, remaining strong and secure
• Insta-Trim's hinges prevent most spray and can be used for transom or bottom mounting

• Designed and manufactured exclusively for Insta-Trim with nylon-reinforced webbing and protective PVC coating
• Rated at 2000 lb. burst pressure, 15' of hose is supplied for your system
• Entering the transom 6" above the water line, the hoses are held securely with hose trim
• Stainless steel clamps hold the hose to barb fitting at the solenoid

• Mounted on the dash they are easy to operate
• 2TP Micro switch with silver contact points adjust the tabs for maximum control and performance
• One pint of Insta-Trim biodegradable transmission oil, funnel and mounting hardware is supplied

Nauticus boat leveler trim tab