Large 2.5”, 222° heat shields fit from the exhaust ports to the chrome billet tips for a seamless look and non-blueing finish
Chromed billet end caps are beautifully machined for show-custom look
Gives overall power increase with improved rideability
Easy installation with all mounting hardware included
Made in the U.S.A.
NOTE: It is recommended that new exhaust gaskets and a proper jet kit be installed when changing an exhaust system on a carbureted motorcycle. It is
recommended that new exhaust gaskets and a Fi2000R digital fuel processor be installed when changing an exhaust system on a fuel-injected motorcycle.
DISCLAIMER: There is no warranty on exhaust pipes and mufflers with regard to any discoloration. Discoloration (blueing) is caused by tuning characteristics, i.e. cam timing, carburetor, etc., and is not caused by defective manufacturing.
DISCLAIMER: Emission-related parts for OEM non-emission control system equipped motorcycles as well as slip-on mufflers
that mount downstream of and which do not alter the performance of OEM emission-related devices are considered legal
replacement parts by the California Air Resources Board (CARB). CARB does not, however, permit the use of aftermarket
emission-related parts that remove or alter OEM emission control devices unless certified by CARB, other than for closed
circuit race use only.
DISCLAIMER: Aftermarket products, including but not limited to fuel/air controllers which alter, modify, or replace emission control devices or systems of an originally compliant highway motorcycle, are not legal for street use in California unless they have been issued a CARB Executive Order. Aftermarket emissions related products which have not been issued an Executive Order or which are not aftermarket Replacement Parts, as defined in Title 13, California Code of Regulations, Section 1900(b)(2), are authorized for closed circuit race use only. See manufacturer’s information and state and local laws to determine what is authorized for your use on your vehicle.
DISCLAIMER: Products shown may be designed, manufactured, intended and sold for closed circuit race use only and use of the same on public roads or lands may be a violation of local, state and/or federal laws.
DISCLAIMER: Products shown may not conform to federal, state or local noise regulations.
DISCLAIMER: Check your applicable laws and manufacturer’s publication(s) for manufacturer’s warranty, maintenance, safety, mounting and any regulatory compliance/ non-compliance information.
